Directions for Use
- Ensure the switch on the dispenser is in the "OFF" position. To open push the button on the back down and pull the front face forward.
- Insert 2 AA batteries. Ensure the batteries are correctly inserted, aligning the positive (+) and negative (-) terminals as indicated.
- Ensure you direct the dispenser away from your face at all times. Insert the refill can, with the nozzle facing outwards, and close the dispenser.
- Select the desired spray interval (10, 20, or 40 minutes) using the switch on the side of the dispenser. Select Day, Night, or 24 hour setting to give desired results. To determine the appropriate spray interval, refer to the table below. When the dispenser is activated, the unit will spray after a delay of 10 seconds. If there is no spray after 10 seconds, switch off the dispenser and check that steps 2 and 3 have been performed correctly before repeating step 4.
- When the refill can is empty, direct the dispenser away from your face and switch to the OFF position, and replace the refill can as indicated in the steps above.
Pest | Area | Interval Setting Mins:* |
Crawling Insects | Less than 20m2 | 20 |
Crawling Insects | More than 20m2 | 10 |
Pest | Area | Interval Setting Mins:* |
Flies | Less than 20m2 | 40 |
Flies | More than 20m2 | 20 |
*If doors or windows are left open or there is a large pest infestation, use one level higher frequency if possible. E.g. change form every 30 mins to every 20 mins.
Dispenser Placement Instructions
Hang the dispenser unit or place it on a horizontal surface at least 2 metres off the ground and no closer than 30cm from the ceiling.
- Recommended for use only in well ventilated rooms larger than 16m3 (3m x 2.2m). Do not install, use or store less than 5 metres away from naked flame or heat, for example near heaters, gas refrigerators, and stoves.
- Avoid installation over furniture, polished surfaces, food preparation areas, or appliances as the contents may stain or damage these surfaces. Ensure the dispenser unit is pointed away from wall surfaces at all times.
- Surfaces may become slippery when sprayed, should this occur clean with warm, soapy water and dry thoroughly.